Assembly Instructions QBT20
6
The payload of the QBT20 swivel bracket is designed of one T20 loudspeaker. Do not exceed
this payload.
WARNING
When moving (assembling, dismantling, maintaining) the QBT20 swivel bracket with
T20 loudspeaker, ensure sufficient space to prevent collisions with other objects.
WARNING
Do not squeeze or twist the electrical cables of the T20 loudspeaker during the installation of
the
QBT20 swivel bracket!
The respective national electrotechnical rules and regulations are
applicable.
CAUTION
All screw connections should be checked each time the QBT20 swivel bracket are installed.
Tighten all loose screws. If this is no longer possible, the screws must be replaced.
WARNING
Before mounting the QBT20 swivel bracket check that e.g. ceilings, trussus and tripods are
capable to carrying the payload of the components.
WARNING
WARNING
WARNING
Make sure that no water pipes, electrical lines or any other lines are behind the intended place
of mounting.
Only use wall plugs and screws which are suitable for the intended mounting and structural
fabric. All screws must be set and tightened properly. Ensure that the fixing holes have the
correct depth and diameter. Always use all fixing holes.
