MAINTENANCE
MAINTENANCE
32
SELF - MAINTENANCE PROCEDURES
BATTERY
Battery is located below the cover frame L. The electrolyte
level of the battery must be maintained to avoid damages to
the battery. To check the electrolyte level, follow the
procedure:
1. Place the vehicle on centre stand on a flat surface and
open the cover frame L as explained in page no. 21.
2. Inspect the battery electrolyte level. It should be
between the minimum and maximum level.
3. If the electrolyte level is below minimum level, add only
distilled water upto the maximum level by removing the
filler caps.
4. Reinstall the filler caps and clean the battery
thoroughly, apply petroleum jelly to the battery
terminals to protect it from corrosion.
Incase of any abnormality or for removal of battery from the
vehicle, contact TVS Motor Company Authorised
Distributor or Dealer / Authorised Service Centers.
Once the battery is charged initially, never add diluted sulphuric
acid. Use only distilled water for topping up. Never add tap water.
Never check the battery charge by shorting the terminals. Always
connect the positive terminal first and then negative to avoid
sparking.
Do not obstruct, bend or change the routing of battery air vent
tube. Make sure that the vent tube is firmly attached to the battery
and the other end is open and clear.
CAUTION
FUSE REPLACEMENT
Non-working of electrical system may be due to safety fuse
failure. Short circuit or overload in the electrical system are
the main cause for fuse failure. Two 10A blade type fuses are
provided for the safety of your bike’s electrical system. One
fuse is given exclusively for head lamp and the next one is
for other electrical systems. Incase of any fuse failure:
