TVS Apache RTR 200 4V, Owner'S Manual

Page: 31 / 118

18
4. Adjustable clutch lever
Press the lever towards grip to disengage the drive.
It is used to disengage the clutch while shifting the
gears.
Failure to switch the turn signal lamp ‘ON’ or ‘OFF’ at the
right time may lead to an accident.
Warning
Clutch lever can be set to your convenience. Refer page
no. 56
Note
5. Pass-by switch
Press the switch to flash the head lamp. It is used to
give signal to the vehicles coming from the opposite
direction while overtaking other vehicles during day.
The head lamp glows automatically once the engine
is started. If the head lamp is glowing in ‘Low’ beam,
on pressing the switch, the head lamp ‘High’ beam
also glows along with the ‘Low’ beam.
If the head lamp is already glowing in ‘High’ beam,
the pass-by system will not work.
Pass by system will not work if the head lamp is glowing
in ‘High’ beam.
Note
6. Head lamp high / low beam switch
The head lamp low beam glows automatically. Only
the head lamp beam (high/low) can be controlled
with the beam control switch.
Press the top end of switch for ‘High’ beam ’ ‘ and
bottom end for ‘Low’ beam ‘ ‘.
Low beam of the vehicle is turned on with Ignition
key ON and high beam is activated once the engine is
started and switch is in High beam position.
Use appropriate head lamp beam ‘high / low’ as per the
traffic and road conditions for your safety and to avoid
inconvenience to other riders.
It is strongly recommended to ride the vehicle in ‘low’
beam during day.
Warning
Only the engine is started the head lamp high beam
glows, provided if the beam control switch is in high
beam.
Note