Chapter4
Chapter4
Chapter4
Chapter4
Maintenance Mode
Soft SW Setting Mode
Soft SW Setting Mode
Soft SW Setting Mode
Soft SW Setting Mode
Set item
Buffer Size
Initial value
4k
Setting value
40byte
Remarks
The receiving buffer size is selected.
4Kbyte
Init Signal
ENB
ENB
DIS
Selects enabled (ENB)/disabled (DIS) of the printer
initialized signal (PRIME) during centro-interface.
Selects enabled (ENB)/disabled (DIS) of the 25pin reset
signal during serial interface.
Buzzer
ON
ON
OFF
Selects buzzer sound when an abnormality occurs as
enabled (ON)/disabled (OFF).
Interface
Interface
Interface
Interface----SW (Displayed only when the serial board is mounted)
SW (Displayed only when the serial board is mounted)
SW (Displayed only when the serial board is mounted)
SW (Displayed only when the serial board is mounted)
Set item
Baud Rate
Initial value
9600
Setting value
19200
Remarks
Sets the baud rate of the serial interface.
9600
4800
2400
1200
Data Length
8 bit
8 bit
Sets the character length of the serial interface.
7 bit
Parity Bit
NONE
NONE
Sets the communication parity of the serial interface.
EVEN
ODD
Stop Bit
1 bit
1 bit
Sets the stop bit of the serial interface.
2 bit
Protocol
DTR
DTR
X-ON-OFF
Mechanical
Mechanical
Mechanical
Mechanical----SW
SW
SW
SW
Set item
Paper Width
Initial value
76.2
Setting value
76.2
Selects the paper size.
Remarks
69.5
57.5
Auto-Cutter
PAR.
OFF
FREE
FULL
PAR.
Selects the cutter operation.
When it is OFF, the FULL/PAR. commands do not start
cutting.
In FREE status, cutting is done according to the
FULL/PAR. commands.
In FULL status, full cut is always done by both the
FULL/PAR. commands.
In PAR status, partial cutting is always done by both the
FULL/PAR. commands.
Color Ribbon
ON
ON
OFF
Selects the color function.
During OFF, the change color command is ignored.
29
29
29
29
