6
4.2 1T-CT-681
Transmitter
1. Connect the HDMI source device’s output to the HDMI IN connector of the 1T-
CT-681 Transmitter, using an appropriate HDMI cable, (3 Meter
(~9’) in length for
12 bit signals, 6 meters (~18’ for 8 bit signals).
2. Mark all five cables on both ends so you do not inadvertently swap them during
installation.
3. Connect
five (5) RG-6 cables
.
Three (3) go to the BNC Video connectors labeled
R-G-B, the fourth cable goes to the connector labeled CLK and, if the total cable
run is
180
feet or less, connect the fifth cable to the BNC connector labeled
“Power” on the Transmitter. Defer connecting the AC adapter until the RG-6
cables are connected to both the Transmitter and the Receiver.
4.3 1T-CT-682
Receiver
