5
4.0
CONNECTING THE HARDWARE
Referring to the drawings below, connect the proper cables and then connect the AC
power adaptor.
NOTE: The resolution capability of the remotely located display devices must be capable of displaying the output of the
source device. Before using the extender system, verify that the display device on the receiving end can support the
output resolution and signal format by connecting it directly to the source device.
4.1
1T-CT-651 Transmitter
1.
Connect the HDMI source device’s output to the HDMI IN port of the 1T-CT-651
Transmitter, using an appropriate HDMI cable, (1 Meter (~3’) in length for 12 bit
signals, 10 meters (~33’) for 8 bit signals).
2.
(OPTIONAL)
If there is an IR controllable device on the 1T-CT-651 side that you wish
to control remotely from the 1T-CT-652 side, connect the IR Emitter device to the IR
Tx connector on the 1T-CT-651. If there is an IR controllable device on the
1T-CT-652 side that you wish to control remotely from the 1T-CT-651 side, connect
the IR Receiver device to the IR Rx connector on the 1T-CT-651.
3.
Connect the Cat.5e or Cat.6 cable to the transmitter via the HDBaseT Out port.
Ensure that the RJ45 connector is securely locked into the transmitter’s port.
4.
If using the RS-232 control feature, connect the RS-232 device to the 1T-CT-651 via
the DB-9 port.
5.
Connect the 5v AC power adapter’s DC power connector to the 1T-CT-651
Transmitter.
