8
1. At the remote location, connect the Cat.5e/Cat.6 cable to the
5HFHLYHU¶V5-
connector. Ensure that the connector achieves a positive lock into the receiver
¶
s
connector.
2. (OPTIONAL) If there is an IR controllable device on the 1T-CT-642 side that you
wish to control remotely from the 1T-CT-647 side, connect the IR Transmitter
device to the IR2 OUT connector on the 1T-CT-642. If there is an IR controllable
device on the 1T-CT-647 side that you wish to control remotely from the 1T-CT-
642 side, connect the IR Receiver device to the IR1 IN connector on the 1T-CT-
642.
3. Connect the HDMI connector of the Receiver to the HDMI input of the remote
display or other device, using an appropriate cable, (15 Meter
(~30
¶LQOHQJWKIRU
either 12 bit signals or 8 bit signals).
4. Connect the AC power adapter
¶
s screw lock DC power connector to the
Receiver. The green LED on the RJ45 port will illuminate when power is present.
5. Turn on the source device and remote display. Observe the Link LED on the
Transmitter and the Receiver. The LED on both RJ45 ports will remain lit when
the link is complete and stable.
1RWH,W¶VLPSRUWDQWWKDW\RXYHULI\'0,VRXUFHIXQFWLRQVSURSHUO\
directly with
the HDMI display device before you attempt to use the system components to extend
the signal distribution distance. Failure to do this introduces an unwanted variable that
would then have to be resolved should the system not function as expected.
5.0
OPERATING THE UNITS
Once the connections have been made and power applied as explained above, there
are no operational adjustments required. It is recommended however that the power on
sequence be as follows: HDMI over Cat.5e/Cat.6 Transmitter and HDMI over
Cat.5e/Cat.6 Receiver, HDMI destination devices and HDMI source
±
in that order.
5.1 EDID Operation
The 1T-CT-
¶VGHIDXOWIDFWRU\
VHWWLQJLV³79´/HDYHWKHVZLWFKLQWKLVSRVLWLRQVRWKDW
WKHXQLWFDQVHQVHWKHSURSHU(','VHWWLQJEDVHGRQWKHGLVSOD\¶VUHTXLUHPHQWV
:KHQILUVWSRZHUHGRQLQ³79´PRGHWKH7
-CT-647 will detect and store the EDID from
Cat5e/6 output port 1 and
LWZLOOVHQGWKDWRXWSXW¶VGLVSOD\IRUPDWLQIRUPDWLRQWRWKH
connected source. The 1T-CT-647 retains in memory the last EDID decision it made,
therefore the device will use the last EDID it stored if output port 1 is not connected to a
display after being power cycled.