7
1. Connect the HDMI source
GHYLFH¶V
output to the HDMI IN connector of the 1T-
CT-647 Transmitter, using an appropriate HDMI cable, (10 Meter
(~30
¶
in length
IRUELWVLJQDOVPHWHUVa¶
) for 8 bit signals).
2. If desired, connect an HDMI capable monitor to the HDMI output connector for
monitoring or cascading purposes. Keep the HDMI cable as short as possible.
3. (OPTIONAL) If there is an IR controllable device on the 1T-CT-647 side that you
wish to control remotely from the receiver side, connect the IR Transmitter device
to the IR1 OUT connector on the 1T-CT-647. If there is an IR controllable device
on the receiver side that you wish to control remotely from the 1T-CT-647 side,
connect the IR Receiver device to the IR2 IN connector on the 1T-CT-647.
4. Connect the Cat.5e or Cat.6 cables to the transmitter via the RJ45 connectors.
Ensure that the RJ45 connectors
DFKLHYHDSRVLWLYHORFNLQWRWKHWUDQVPLWWHU¶V
connectors.
5. C
RQQHFWWKH$&SRZHUDGDSWHU¶V
screw lock DC power connector to the
Transmitter. The power LED on the front panel will illuminate when power is
present. The SYNC LED will light when a valid HDMI signal is connected to the
input. The HDMI Link LED will illuminate when an HDMI capable monitor is
connected to the HDMI Output and Link LEDs 1 through 7 will light when an
appropriate receiver is connected to each Ethernet cable at the far end.
4.2
1T-CT-642 Receiver (Recommended
±
must be purchased separately)