8
3. Connect the HDMI connector of the receiver to the HDMI input of the remote
display or other device, using an appropriate cable, (15 Meter
(~30
¶LQOHQJWKIRU
either 12 bit signals or 8 bit signals).
4. Connect the AC power adapter
¶
s screw lock DC power connector to the receiver.
The green LED on the RJ45 port will illuminate when power is present.
5. Turn on the source device and remote display. Observe the Link LED on the
Transmitter and the Receiver. The yellow LED on both RJ45 ports will remain lit
when the link is complete and stable.
1RWH,W¶VLPSRUWDQWWKDW\RXYHULI\'0,VRXUFHIXQFWLRQVSURSHUO\
directly with
the HDMI display device before you attempt to use the system components to extend
the signal distribution distance. Failure to do this introduces an unwanted variable that
would then have to be resolved should the system not function as expected.
5.0
OPERATING THE UNIT
Once the connections have been made and power applied as explained above, there
are no operational adjustments required. It is recommended however that the power on
sequence be as follows: HDMI over Cat.5e/Cat.6 Transmitter and HDMI over
Cat.5e/Cat.6 Receiver, HDMI destination device and HDMI source
±
in that order.
6.0 TROUBLESHOOTING
In the event of problems, first make certain that the input and output cables are no more
than 15 meters long (for signals to 1080p resolution) and are of the highest possible
quality. Next, make certain that both extender products are receiving power.
If all is well in these areas, remember that HDMI devices communicate with one another
so the source device and destination device must be fully HDMI capable. In addition,
HDCP encryption requires additional processing which also is dependent on the
equipment you have connected to the source and destination device. If you experience
problems using the HDMI over single Cat.5e or Cat.6 products, you should attempt to
determine what is wrong by attaching the source device directly to the destination
device using the same cable you are using with the extended system. This is a way of
determining if the problem is due to bad cables or a problem with other devices. If you
are unable to obtain a signal using this simplified path, suspect the cables, the source
device or the destination device.
After trying the above suggestions should the problem still persist, contact your dealer
IRUDGGLWLRQDOVXJJHVWLRQVEHIRUHFRQWDFWLQJWY21(6KRXOGWKHGHDOHU¶VWHFKQLFDO
personnel be unable to assist you, contact tvONE via our support website:
http://tvone.crmdesk.com.
Create a technical support request on the site and our
support team will respond within a short period of time.
