4
3.0 CHECKING PACKAGE CONTENTS
Before attempting to use this unit, please check the packaging and make certain the
following items are contained in the shipping carton:
•
1x Transmitter, 1x Receiver unit
•
2x Power Adapters
•
1x Operations Manual
Note:
Please retain the original packing material should the need ever arise to return
the unit. If you find any items are missing, contact your reseller or TV One immediately.
Have the Model and Serial Number and Invoice available for reference when you call.
4.0 CONNECTING THE HARDWARE
Please study the panel drawings below and become familiar with the signal input,
outputs, power requirements/inputs plus any controls present.
Note: The resolution
capability of the remotely located display devices must be capable of displaying the
output of the source device. Before connecting the CAT.5 extender system, verify that
the display device on the receiving end can support the output resolution and signal
format by connecting it directly to the source device.
4.1
Cat.5/5E/6 Cable Notes
Pins and pairing.
Make sure the CAT5/5E/6 cable pin assignments are standard. The
correct pairing is straight through pin-to-pin, with pairing as follows.
Twist density.
UTP cable pairs have different twist densities (twist pitches). There are
two pairs with high density twist and two pairs with low density. Colors vary by
manufacturer. Twist densities can be seen by stripping off about 10 cm (4’) of insulation
and visually inspecting. Pairs 1-2 and 7-8 should be assigned to high density twists.
Failure to assign correct twist densities can result in image jitter. The ABCD picture
shows typical UTP cable, with pairs A and C showing a high pitch twist (assign (assign
to pin pairs 1-2 & 7- 8), and B and D with low pitch twist (assign to pin pairs 3-6 & 4-5).
