tvONE
2
Using the ONErack Spider Power Module
This ONErack Power Module is suitable to be fitted to either the
ONErack Spider Strip, or the Half 7.
The power module needs to be configured to the required voltage of
your 3
rd
party equipment.
If you are replacing a faulty Module, you may not need to re-do the
‘Prepare the Lead’ section.
Power Modules
To set the correct voltage output [shipping default voltage = 5V]
and connect your device to the output of the power module,
you may need the following tools: -
Pozidriv® PZ1 crosshead screwdriver
Wire cutters
2mm flat head screwdriver
Wire strippers
Voltmeter
Setting the Output Voltage
1.
Unscrew and remove the module or blanking plate from the
ONErack Spider PSU using the Module Extractor (received
with your original unit) as shown.
2.
Turn the switch inside the module until the white dot points
to the correct voltage for your device(s).
3.
Insert the new Module into the ONErack Spider PSU and
tighten screw. Using one of the Voltage stickers (received
with your original unit), apply to the end of the screw that
holds the Power Module in place.
Summary of Contents for 1RK-SPDR-PWR
Page 2: ......
