923211006
_09_00
1
Page
3 from 4
Figure 1
1.
To instal the device you have to dismantle carefully the device with a flat screwdriver as
shown on figure 1.
2.
Pass the mains cables through the hole (point 1 on figure 2).
The luminaire must be
connected to a permanent electrical installation
to ensure
the
immobilization of the cable.
3.
Mount the base plastic on the wall by using the included mounting accessories in points 2
and 3 on figure 2.
4.
Connect the battery`s cable with the appropriate terminal (figure 3).
5
.
Connect the mains cables to the respective detachable terminal block
.
Ν
for neutral
,
L for live
wire
and
L1 for the
maintained operation
.
The L
1
wire can be connected to an external switch
to control the maintained or non maintained operation of the luminaire
.
For permanent maintained
operation use two wires to power the luminaire,
Ν
for neutral and L for live wire, and link the L and
L1.
(figure 3) Minding the
correct polarity. Depending on the module that will be used, the cables that will be used, have
different names. In A, L, C are also connected, while signals -L, NC/NO in the terminal B.
6
.
Refit with care the removed plastic parts and power on the luminaire.
If you use a module pass the 2 signal cables on the A, B terminals
Controled operation
of the illumination source
NOTE!!
After finishing the installation you must power the luminaire at least for 24 hours for battery charging to perform the nominal
autonomy.
INSTALLATION INSTRUCTIONS
2
3
Figure 2
Figure 4
1
N
N
L
L
External
switch
Link
Permanent
operation of the illumination source
N
N
L
L
L1
L1
Battery’s
connector
Figure
3
Α
Β