background image

tuuci

  | 

7

 

INSA2000

ASSEMBLY & OPERATING INSTRUCTIONS

CARE & MAINTENANCE

TUUCI frames are constructed from durable, marine-grade, weather resistant materials including: fiberglass, 
armor-wall aluminum, Dura-TEAK composites, Aluma-TEAK aluminum and sustainable hardwood. All fasten-
ers (nuts, bolts, pulleys, cam cleats, etc.) are marine-grade stainless steel and will withstand the most corrosive 
environments. Proper care and maintenance is important to extend the serviceable life of all TUUCI products. 
We recommend the following:

 

• Fresh water rinses once a week

 

• Weekly inspection of your TUUCI product is recommended. Loose screws should be tightened and any

 

   broken components replaced immediately to avoid further damage to your product.

 

• Prior to opening, ensure that the shade product is properly secured to an adequate shade anchor system.

 

• When opening a TUUCI parasol, separate each rib 10 inches from the center post, before raising the hub.

 

   Do not force hub if it does not rise easily.

 

• When closing the parasol, pull the fabric out from between the struts to avoid pinching or damaging the

    

   TUFF-SKIN canopy membrane.

 

• TUUCI recommends that all collapsible shade equipment be closed in wind conditions which exceed 25 MPH.

 

• Clean above ground parasol bases regularly to maintain appearance. To clean, gently wash with soap and 

 

   water using a nonabrasive cloth or pad.

 

• Check bolts in security stem regularly to ensure that they remain fully tightened. 

 

• Do not roll Aluma-crete (Aluminum Shell, Concrete Filled) bases on their side as damage to shell

 

   or finish can occur.

 

• Do not use on stairways or over distances which exceed 50 feet, as damage to welded wheel tray may occur.

 

• Canopy should be cleaned regularly and can be cleaned without being removed from the frame. Hose down 

 

   and clean with a mild soap and lukewarm water (no more than 100° F.) using a soft bristle brush. Rinse thor

 

   oughly to remove soap. Allow fabric to air dry. TUUCI Parts can be purchased at [email protected].

                 • Do not use a pressure washer to clean canopes.

Summary of Contents for OCEAN MASTER MAX series








Reviews: