70
11
TSC Printer Installation (optional)
The following is a user's set up guide that explains describe:
General printer information.
Safety instructions
How to install TSC printer and connect it to the T Edge autoclave for the first time.
(Shall be performed by qualified personnel).
How to set, operate, use and maintain the printer after the first installation.
General printer information
The printer(s) are optional and can be purchased/ordered from Tuttnauer by the customer,
the printers can easily be installed and connected to the autoclave following the
instructions below.
The options includes:
One printer connected to the autoclave, and can be loaded with thermal paper roll,
or with label roll. The user can direct the printer to switch between printing on
thermal paper roll or label roll.
Two printers connected to the autoclave, one loaded with thermal paper roll, and
the second printer is loaded with label roll.
11.1.1Printer Output:
The autoclave is equipped with a character printer, which prints a detailed history of
each cycle performed. (This can be used for the record or for subsequent
consideration.)
The printing is on thermal paper with a defined set of characters per line and contains
important information such as some of the main following details:
Date:, Time: , Ser. Num:, Model:, Version:,
Cycle Num:, Cycle Name:, Ster Temp:, Ster Time:, Dry Time:,End Temperature
When the sterilization cycle begins the printer starts printing the above data.
After the preliminary printing, the autoclave starts performing the sequence of operations
of the cycle. The measured values of temperature and pressure are printed at time
intervals, according to the phase of the process, as shown in the table on the next page.
The data is printed from the bottom up, beginning with the date and ending
with "Cycle Ended". For an aborted cycle, "Cycle Failed" and the Error
message are printed (refer to "Displayed Error Messages/Symbols").
The printer can also print labels when loaded with label roll and printer1 is
selected.
For an example of a typical printout, see next page.
