Page 62
9.4 Tubing
When placing tubing on the tray, make sure that both ends are open,
without sharp bends or twists.
9.5 Liquids
Use only heat-proof glass, filled 2/3 full.
Ensure that the glass container is covered but not sealed to prevent
pressure build-up.
Note:
For isothermal cycles, insert one PT100 temperature sensor into the
liquid, and allow the other PT100 temperature sensor to hang loose
inside the chamber, (see the figure below).
For proper sterilization, ensure all the bottles are filled with
approximately the same amount of liquid.
Wrong
Right
