RF WIRELESS CAMERA SYSTEM
INSTALLATION AND USER GUIDE
5 |
P a g e
3. Installation
Wireless Backup Camera Installation:
Mechanical Installation:
Remove the plastic shrink wrap from the RF Wireless Backup Camera. Attach the provided antenna to the RF
Wireless Camera by screwing it in place using only your fingers to tighten in place. Select the appropriate mounting
location for your camera. To obtain the best camera performance we recommend that the RF Wireless Backup
Camera be mounted as high on the rear end of the trailer or vehicle as possible to do so. The antenna of the backup
camera should be above the top of the trailer or vehicle if possible to do so for best performance. Another
consideration is the location of 12 VDC power
required to operate the camera. We recommend that
the camera be centered in the trailer for best backup
viewing. One option you may have would be to locate
the backup camera near the center trailer running
lights. Once you have selected the best mounting
location, remove the two (2) Phillips head machine
screws from the backup camera. Once removed the
sunscreen, camera and mounting base are now
loose. Keep the two (2) Phillips head screws for
reassembly of the camera.
Fasten the camera mounting bracket to the trailer
mounting location using at least two (2) mounting
screws and washers (mounting screws and washers
not included.) The RF Wireless Camera can be
damaged or destroyed if not securely fastened to
your vehicle! Tuson Corporation assumes no
responsibility for damage as a result of and improper
installation. Once the mounting bracket is securely
mounted to the trailer, reassemble the camera and
sunscreen to the mounting bracket using the two (2)
Phillips head machine screws. Tightening these two
Phillips screws will fix the camera viewing angle in
the vertical and fix the position of the sunscreen
simultaneously. Tighten these two (2) Phillips screws
fully to lock the RF Wireless camera into the
mounting bracket.
In order to get better wireless transmission between camera and display, place camera as high as possible.
It is suggested the camera's antenna be over the roof.
Electrical Installation:
The RF Wireless Backup camera has a bonded pair of 14 AWG lead wires colored red positive (+) and black ground
(-). Connect the positive red camera lead wire to the 12 VDC power circuit positive wire (+) using a weather proof
electric connector. Next connect the black lead ground (-) wire from the camera to the ground circuit (-) wire using
the weather proof electric connector provided.
Wireless Backup Camera
Red wire: +12 voltage. Black wire: Ground.
