①
Check your surroundings.
Always confirm that nothing can obstruct or become entangled in the propeller.
②
Place the scooter vertically on a level surface.
③
Turn on the main switch. It is located on the right hand grip.
①
Push up the accelerator lever.
②
Slowly push up and down on the accelerator lever.
③
Confirm rotational speed changes are occurring
with vertical motion.
④
Also, confirm the sound of propeller for check.
⑤
Check the battery indicator for battery condition with turning on the motor.
⑥
Take all pressure off the accelerator lever.
⑦
Confirm the rotation of the propeller has stopped completely.
●
Confirm that all lights are illuminated. (i.e. Green, yellow, and red)
●
It is necessary to synchronize the battery indicator for each type of battery (Lithium ion or LEAD-ACID /
Ni-MH) to ensure an accurate display of the remaining battery life. (Refer to STEP 2 on page 15)
●
The display accuracy may be affected by an exhausted battery and ambient temperature.
Please refer to the battery indicator as a rough guide only.
Lights the Battery indicator
Push the accelerator
lever up and down.
All colors are tuned on after full charged, then changed
color with consumption.
About battery indicator
■
STEP1
Turning on the main switch.
■
STEP2
Checking the battery indicator light.
■
STEP3
Operate the motor.
Check before use. (confirming operations)
Check the indicator
Check the noise
●
Red : empty
●
Yellow
●
Blue : full
●I
n case of using Lead-Acid / Ni-MH battery, green LED does not
always turn on even if at full charge.
●
Indicator operates following by battery voltage at propeller pitch 2 with full throttle.
Please note that it can not be measured accurately because the battery voltage is recovered
gradually when the motor Is stopped
.
WARNING
●
If switch is left on the standby current will continue to flow.
It is possible that damage will occur from over discharge of the battery.
WARNING
●
Do not miss the check before diving in order to prevent from serious injury.
●
Move the main switch to off position.
●
Confirm that all battery indicator lights are off.
Main switch OFF
●
Lay the scooter down on a level surface.
●
Pull and turn the pitch control dial knob to make adjustments
to the propeller angle.
●
Push the dial back after speed selection.
●
SAV-7 EVO2 DPV: Confirm that pitch operation moves smoothly through the three stages.
●
SAV-7 EVO2 DPV: Recommended position is Pitch 2 or 3 because of law consumed power.
Acceleration purpose
(need more power for pulling a heavier person or weight - reduces battery life)
Standard purpose
(most efficient setting)
Low speed purpose
■
STEP4
Turn off the main switch.
■
STEP5
Using the variable pitch propeller.
Pitch selection
Lay the scooter down on a level surface
Pull the pitch dial
Choose the speed level
with pulling dial
17
11
