Turtle Beach Ear Force X32, User Manual

Page: 8 / 32

5
TO
NE
R
Pairing the Headset and Transmitter /
Couplage du casque et de l’émetteur
1
2
3
Step 1:
Make sure the headset and transmitter are
turned off and they are at least 2 feet away from
each other.
Step 2:
Power on the transmitter by connecting it to a free
USB port on your gaming console. Then press
and hold the PAIR button on the transmitter for
about 5 seconds. Release the PAIR button when
the transmitter’s Power/Link LED begins to flash
rapidly (twice per second). NOTE: If you hold the
transmitter’s PAIR button for too long (over 20
seconds), the light will blink extremely quickly, and
you will need to start over from step 1.
Step 3:
Press and hold the headset Power button for about
6 seconds until you hear the second double beep,
then release the Power button. At this point, the
headset LED will flash rapidly (twice per second).
Step 4:
Wait for the headset and transmitter to pair. This
process could take up to 30 seconds.
If pairing is successful, the Power/Link LeD on
the transmitter should be on solid and the headset
LeD should be flashing about once per second,
indicating that the units are paired.
If pairing fails, repeat steps 1-4. It may take up to 5
attempts to pair successfully.
NOTe: Only one headset can be paired with the
transmitter. If you pair two headsets with the same
transmitter, they’ll interfere with each other as
they compete for the transmitter RF signal. This
will cause one headset to shut off. So don’t try to
pair two headsets with the same transmitter!