Turfmech Buffalo 20, Operator'S & Parts Manual

Page: 13 / 40

13
7.0 Maintenance
WARNING – Stop the engine and remove the spark plug cap
To ensure long and reliable service, carry out the following maintenance regularly:
Regularly check for obvious defects such as a loose, dislodged or damaged blades,
loose fixings and worn or damaged components.
Check that covers and guards are undamaged and correctly fitted. Carry out
necessary maintenance or repairs before use..
Clean the exterior of the machine thoroughly using a soft brush and cloth. Remove all
debris, especially from the air filter and engine fins.
If the mower should happen to fail despite the care taken in manufacture and testing,
repair should be carried out by an authorised Allett dealer.
7.1 Adjusting land drive and cylinder cables
If the mower or cylinder doesn’t drive adequately it may be necessary to adjust the
drive cable as follows:
1) Slacken lock nut
2) Turn the adjuster a few times clockwise
3) Retighten the adjuster with the lock nut
When correctly adjusted, drive to the land roll or cylinder is engaged when the bail
bar is squeezed against the top handle. When released drive MUST disengage.
7.2 Checking the engine oil
Change the engine oil after the first 8 hours of use. The oil should then be changed
every 50 hours or at the end of each season before storage, whichever is sooner.
1) With the mower standing on level ground, unscrew and remove the engine oil filler
dipstick (15)
2) Wipe the oil filler dipstick clean: insert the oil dipstick, then remove it again. Do not
screw it in.
3) Check the oil level
4) Add a good quality SAE 10W-30 oil in small quantities at a time, allowing it to
settle. Repeatedly add oil and check the level until it reaches the upper limit.
1 & 3
2