www.BridgeburgGolf.com
4
6
Mode pin
Located on the tank side at the top of the frame.
Only on the Turf Chopper and TC Split Fame models
The Mode Pin is used when you are changing between modes.
To convert your Turf Chopper back and forth between walking and riding mode you will need to remove and
replace the mode pin after each change has been made.
To remove the mode pin you simply poll the key ring tab straight out from the frame.
T replace the mode pin push it back threw the whole making sure that the pin has gone completely threw
and is visible from both sides of the frame.
This pin is also a safety feature. It is acts as a crumple point designed to reduce impact force on front end
contact so always keep the pin in.
7
Charging Port
Located at the right side of the frame on the front body panel.
This is where you plug the AGM Battery Smart Charger into all Turf Choppers products
Charging instructions:
•
Plug in the battery charger and then plug the male end of the battery charger into the female re-
sceptical on the Turf Chopper.
•
When first plugged in the charger light will glow "Red". When fully charged the light will glow "Green"
It is recommended to recharge after every use.
Note: Use only the charger that came with your unit or replace or recommended from Bridgeburg Golf.
Lithium batteries
charging port is located under a siding panel on the top of the main body panel.
8
Steering Damper
Located on top of the front fork
.
The steering damper is an adjustable clamp used to tighten or loosen the steering stiffness.
The steering damper is used when in walking mode to tighten the steering to reduces wondering. This
allows you maintain smooth straight forward operation while lowering the operators
control requirements.
This clamp can be adjusted to suit any operator’s preference.
Do not over tighten.
Always loosen when converting back to riding mode.
