turck TBEN-S Series, Instructions For Use Manual

Page: 19 / 244

V04.00 | 2021/05
19
5 Mounting
The device can be mounted on a DIN rail according to EN 60715 (TS35) or screwed onto an
even mounting plate. Both composite and individual assembly are possible.
5.1 Mounting the device in Zone 2 and Zone 22
DANGER
Explosive atmosphere
Risk of explosion through spark ignition
When used in Zone 2 and Zone 22:
„
Only install the device if there is no potentially explosive atmosphere present.
„
Observe requirements for Ex approval.
5.2 Combine TBEN-S modules for mounting
The modules can be mounted individually or in combination as a group of modules on a
mounting plate or DIN rail.
5.2.1 Combine TBEN-S modules for composite mounting to a mounting plate
The TBNN-S0-STD connector serves for composite mounting of TBEN-S modules on a mounting
plate:
„ Unlock the cover flap at the connector with a flat tool (e.g. screw driver) (1).
„ Open the flap completely (2).
„ Connect the module and the connector so that the spring of the connector is inserted
into the groove of the TBEN-S module (3).
„ Flap back the cover and close it (4). It has to engage audibly.
„
Repeat steps 1 to 4 until the module group in complete.
1
2
3
Fig. 9: Step 1 Fig. 10: Step 2
4
Fig. 11: Step 3 Fig. 12: Step 4