Central bracket ( 1 )
Support legs ( 2 )
Extension tubes ( 2 )
User guide
BOX CONTENTS
ASSEMBLING THE BRACKET
PLACE BRACKET ON THE WINDOW
IMPORTANT SAFEGUARDS
Support Rail
Extention Tube
Tube Rail
Support Leg
Hitch Spring
1. This product is not designed to support the weight of people or animals. Do not place children
on the unit or attempt to use it as a support for any of the above.
2. Please be aware that this product does not reduce, eliminate or mitigate the requirements of
any air conditioner manufacturer in the mounting and installation thereof.
3. This product works with single or double hung windows only. It does not work in slider, crank-
out or casement windows.
4. Objects including but not limited to awnings, signage, lighting or masonry structures
surrounding a window could potentially obstruct or prevent the proper installation if this
product.
5. Make sure the width of the window is no less than 24 inches and greater than 38 inches.
6. Install the bracket from inside. Do not fully lean out of window.
7. Not for use on dormers. Ensure there is 10 inches min. of clearance below window
8. Do not overload the bracket in excess of its maximum capacity to 200 lbs.
9. If this product appears to be damaged in any way, do not install and/or attempt to use it to
support your air conditioner.
10. Please contact TURBRO Customer Support via [email protected] for help if you don’t
understand these directions or have any doubts about the safety of the installation.
Slide the support leg into each of the two support rails while holding in both locking button on
either side of the support leg.
Release locking buttons to lock the support legs in position. You can adjust this positioning when
placing the bracket in the window by holding in the buttons, sliding the support leg to the desired
position, and releasing the buttons to lock it into place once again.
For further stability, insert the extension tubes into each side of the beam rail while pressing the
locking button.
Release locking button so that each extension tube sticks out from the outer hole of the beam rail,
thus locking it in place at your desired length.
Adjust each extension beam until they are able to be positioned securely inside the window
(see figure 1) or in the window track (see figure 2).
Position the foot pads to rest on the exterior surface. This is done by pressing both locking
buttons and sliding the leg to firmly secure it against exterior surface, with slight downward tilt
(about 1/4" to 1/2") toward the outside for drainage (see figure 3).
1
2
3
Foot Pad Flat Against Wall Surface
Make sure locking buttons are fully seated in holes.
Place air conditioner on the bracket.
