user manual
MILAN
MILAN user manual
Page 7
Getting Started
LINE
LINE
MIC
MIC
BASS
TREBLE
MIX OUT
BASS
MODE
LIMIT
-6dB
POWER
_
0
+
_
0
+
LEVEL
INPUT 1
INPUT 2
LEVEL
MIN
MAX
MIN
MAX
A B
1.
Turn the level controls fully anticlockwise (MIN) on both input channels.
2.
Set the Bass and Treble tone controls to their centre position (no boost or cut).
3.
Connect your signal sources (mixing console, keyboard, microphone, acoustic guitar) to
the input connectors and select MIC or LINE as appropriate for that source.
4.
If the loudspeaker is to be used as a floor monitor, or for use with subwoofers, set the
BASS MODE switch to the ‘B’ position; otherwise select the ‘A’ position.
5.
Switch on the mixer or other source and make sure the output faders or master output
level controls are turned fully down.
6.
Connect the AC mains cable to the Milan loudspeaker and turn on the mains switch. The
blue POWER LED will illuminate to indicate that mains power is connected.
7.
Increase the output level of the signal source to a normal operating level.
8.
Slowly turn up the Milan loudspeaker’s level control(s) until a suitable volume level is
reached. The green SIGNAL LED illuminates when the input signal is -6dB from limiting.
It is normal for the LIMIT LED to flash occasionally, but excessive or prolonged
illumination indicates that the input signal is too high or additional speakers are required.
9.
When shutting down the Milan system, first turn down the input level controls, then
switch off the mains power before turning off the mixer or signal source.
