6
DAILY MAINTENANCE
Step 5: Clean the Oven Interior and Sled
• Use a food vacuum or damp towel to remove large particles from the oven cavity
and sleigh.
• Spray TurboChef Oven Cleaner on the top surface of the oven sleigh and onto the
top, bottom, and sides of the interior
CAUTION: DO NOT spray Oven Cleaner into any holes on the oven
wall. Doing so can damage critical oven components, resulting in a
non-warranty service call.
• Allow Oven Cleaner to penetrate stains for 10 minutes.
• Clean the oven interior and sled with a nylon scrub pad.
• Use a clean damp towel to wipe surfaces.
Step 6: Clean the Air Filters
CAUTION: TurboChef does not recognize blocked air vents as a warrantable
claim. The filter must be cleaned regularly or replaced if damaged. During oven
operation, the filter must remain in place at all times.
• Remove the air filters from the back of the oven.
• Rinse the air filters with hot water.
• Allow the air filters to dry completely.
CAUTION: DO NOT operate the oven without the air filter in place.
Step 7: Reinstall Components
• Reinstall the top and bottom jetplates. When installing the jetplates, make sure the
top jetplate sits above the marker and the bottom jetplate sits below the marker
(step 7, figure A).
• Reinstall the doors. F Make sure the door notches align with the slots on the sleigh
(step 7, figure B). Secure the door clamp.
• Reinstall the oven racks. The Rapid Cook Module has a notch that must be installed
facing the door (step 7, figure C).
• Reinstall the air filters.
Step 8: Clean the Oven Exterior
• Wipe the oven exterior with a clean, damp towel.
• Before wiping down the user interface, touch the three bars in the top-left
corner to access the “Clean Screen” mode (page 10, figure 5). When this option is
selected, the screen will temporarily lock for 10 seconds to allow for cleaning.
CAUTION: DO NOT spray chemicals into any openings, such as the louvers
on the side panels or the rear vent catalyst housing. Doing so can damage critical oven
components, resulting in a non-warranty service call.
• The oven is ready to turn on.
Step 5
Step 6
Step 8
Step 7 (figure A)
Clearance
Lines
Step 7 (figure C)
Step 7 (figure B)
