TurboChef C3/C, Service And Repair Manual

Page: 33 / 107

TEST
5-3
3. Use the top right SOFT KEY to move the
cursor to the right.
4. Use the NUMERIC KEYPAD to change the
digits as follows:
A) Press the key once to enter the number.
B)
Press
the key twice to enter the first letter.
C) Press the key three times to enter the
second letter.
D) Press the key four times to enter the third
letter.
E) Press the key five times to enter the
fourth letter; if applicable.
5. Press the ENTER KEY to store the new
number.
Cook Cycle Count
The CCC key displays the cook cycle count. The
count is incremented when the cook process
completes at least the first event. The count
includes test cooks selected while in the edit
function. To reset the count, press the zero “0”
key.
PIN Number
The PIN key is used to enter a new personal
identification number (password) for accessing
the edit function. When the button is pressed the
display reads:
ENTER PIN _ _ _ _
Use the numeric keypad to enter the new PIN.
Only numbers are applicable for the PIN.
Temperature Units
The F/C key alternately selects Fahrenheit or
Celsius for temperature displays.
Cook Fault Counter
The FAULTS or FF key is used to read and reset
the oven cook fault counters. Press the 0 key to
reset the fault counter displayed. On ovens with
FF repeat pressing the FF button to view all six
fault counters. The faults include:
•
BLOWER STATUS
(blower motor speed
controller)
•
LOW COOK TMP (cooking temperature)
•
LOW MAG CURR (microwave current)
•
LOW MAG FLUC (rf power fluctuations)*
•
MAG OVER TMP (magnetron over
temperature switch)
•
ELEC OVR TMP (electronics compartment
over temperature detection)
•
DOOR MONITOR: (cook door monitor
switch out of sequence)*
* NOTE: The C3/C model and late model C3/AB
oven will have the LOW MAG FLUC error
message replaced by the DOOR MONITOR error
message.
Idle Airflow
The first press of the IAF key displays the
selected idle airflow. Subsequent presses of the
IAF button increment the idle airflow in 10% steps
from 20% to 50%. When the idle airflow is 50%,
the next press sets the airflow to 20%. All ovens
are factory set at 30%.
DIAG
TEST C3ADV
CC 81
O
F HX 500
O
F
2nd Screen: Test Mode
CCC
PIN
F/C
O ELEC
IAF
P S M t h H A W
BLOWER
TEST C3ADV
CC 81
O
F HX 500
O
F
1st Screen: Test Mode
FAULTS
STEST
HEATER
MGTRON
S/N
P S M t h H A W