15
Final Grill Assembly Step
When you have finished assembling your grill,
be sure that all screws are tightened for safe
operation of your grill.
Before each use of the grill, make sure the
Grease Tray is fully seated under the Grill Bowl.
CAUTION: Before each use of your grill, inspect
the Grease Tray, Grease Tray Heat Shield and in-
side of the Grill Bowl to be sure there is no exces-
sive grease and debris buildup. Clean the Grease
Tray, Grease Tray Heat Shield and inside of the
Grill Bowl frequently to eliminate grease/debris
build-up and to prevent grease fires.
For Model BTH3221BLP/NG
Warming Rack
Cooking Grids
Flame Tamer
With Ceramic
For Model BTH2621BLP/NG
Warming Rack
Cooking Grids
Flame Tamer
With Ceramic
Install Cooking Components
9
Place the flame tamer with ceramic onto the
lower ledge of the grill bowl above the burners.
Place the cooking grids onto the upper ledge
of the grill bowl above the flame tamer racks.
Place the warming rack onto the warming rack
brackets on the grill bowl side panels.
Spark Electrode Tip
Spark Receiver
Spark Gap 3/16"
Gas Collector
Box
AA Battery may be installed backwards.
Electric wires may be loose. Remove the AA Bat-
tery and inspect the Ignitor Junction Box found be-
hind the Control Panel and reconnect any loose
wires.
-
-
Main Burner Electrode Check with the
assistance of another person, perform
this Electrode Check before proceeding.
8
Be sure all control knobs are set to "OFF" and
open the grill lid.
Have your assistant stand to the right of the grill
and look toward the front of the grill bowl.
Push and hold the ignition button. Your assis-
tant should see a blue spark within each gas
collector box. If a spark is present, the electrode
tips are properly positioned.
Never
put your face
inside the grill head.
If no spark is seen, the spark gap needs to be
adjusted as follows:
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily.
•
•
If the gap between the spark electrode tip and
receiver is more than 3/16" wide use needle
nose pliers to gently squeeze the gas collector
box to narrow gap.
Recheck the electrode again, if no "clicking" sound
is heard:
Install Ignitor Battery
Remove Ignitor Cap from Control Panel.
Place supplied AA battery into the Ignitor Slot
with positive pole facing you.
Install the Cap and Spring over the AA battery
and tighten securely.
7
Ignitor Cap
Ignitor Slot
AA Battery
Spring
+
-
