Tulsa RUFNEK 130, Service Manual, Page: 8 / 29

8
BRAKE SECTION DISASSEMBLY
CONTINUED
6. To disassemble the brake driver/clutch
assembly, remove the retaining ring (66)
from either end of the driver. Then, remove
the brake driver (69) and bearing (67) from
the input driver (64). Next, remove the
sprag clutch (95). Finally, remove the
retaining ring (66) from the other end of the
driver, then remove the second bearing (67)
from the input driver.
Notice the direction of lock-up
on the clutch (95) for re-assembly.
7. Remove the bearing housing (68) and
inspect the bearing (50).
8. If the bushing or seal in the brake housing
needs to be replaced, follow the drum
section disassembly and reassembly
sections of this manual prior to reassembly
of the brake.