Tuft & Needle Adjustable Frame, Owner'S Manual, Page: 42 / 56

42
Saving a Memory Position
There are two pre-saved Memory Positions: Anti-Snore
(Position 1) and Zero Gravity (Position 2). Press the Memory
Position Buttons on the Remote Control to move to these
positions. You can change saved Memory Positions to
new Memory Positions. To do this, proceed as follows:
1. Press and hold the UP or DOWN Button for the
Platform you wish to adjust
2. Wait until the Bed Frame has reached the desired
position
3. Release the UP or DOWN Button
4. Press and hold the Button for the new Memory
Position for at least 3 seconds
5. Release the Memory Position Button to save position
Performing a Flat Position Reset
To perform a Flat Position Reset, press the Sleeping
Position Button for at least 15 seconds, then:
1. The Remote Control displays “F” to confirm the input.
2. Press and hold the Sleeping Button again to move the
bed to the flat position
3. The Reset is complete
If two beds are in Wireless Sync Mode, turn off Wireless
Sync and reset each bed separately.
Moving the Bed Frame to a Saved Memory Position
Proceed as follows to move the Bed Frame to a saved
Memory Position:
1. Press the Memory Position Button for the Memory
Position you wish to move to (for less than three seconds)
2. Wait for the Bed Frame to move to the saved
Memory Position
Moving the Bed Frame to the Sleeping Position
The Sleeping Position is the Bed Frame’s lowest
position. While in the Sleeping Position, all Platforms
are horizontal. Proceed as follows to move the Bed
Frame to the Sleeping Position:
1. Press the Sleeping Position Button (do not hold
the Button)
2. Wait for the Bed Frame to move to the Sleeping
Position