15 Trouble Shooting
1. Unit not tracking or is fishtailing
2. Unit not tracking: skipping, jumping, and
fishtailing (in untilled, hard soil)
3. Unit leaving water furrow in center.
4.Unit ridging or leaving behind a high spot in
center of machine.
5. Unit leaving water furrows on outside
of each rear gang.
6. Blades plugging with soil or trash.
7. Unit leaving a balk between front inside
gangs.
A. Adjust top link to increase weight on the rear of the
disc.
B. Disc assembled incorrectly. Refer to assembly in-
structions.
A. Insure equal cut or depth on front and rear.
B. Reduce speed.
C. Reduce gang angle.
D. Reduce depth of cut by carring on 3 point lift discing
shallow the first time over. NOTE: Some experimen-
tation may be required by trial and error to arrive at
proper solution.
A. Increase speed.
B. Increase angle on rear gangs.
C. Decrease angle on front gangs.
D. Disc not level. Lower rear gangs or raise front
gangs.
E. Any combination of the above.
A. Decrease speed.
B. Decrease angle on rear gangs.
C. Increase angle on front gangs.
D. Disc not level. Raise rear gangs or lower front
gangs.
E. Any combination of the above
A. Add optional T70316 outrigger attachment with a
round disc blade about 4” smaller than stock blades.
A. Add optional scraper kit (Page 11). If already
equipped, re-adjust them.
B. Soil conditions not suitable for discing due to exces-
sive moisture.
A. Add optionl 11477 center sweep balk breaker as-
sembly (Page 12).
Gang Adjustment Trouble Shooting