Tubeline Accumul8, Operator'S Manual

Page: 11 / 63

2-4 Section 2 - Safety - Ac2/+4
manufacturer will not be responsible for injuries or damages caused by the use of unapproved parts and/or
accessories.
6. A fire extinguisher and first aid kit should be kept readily accessible while performing maintenance on this
equipment.
7. Do not weld on or near rotating parts. Welding close to rotating parts may cause warping thus creating high
stress loads for moving or rotating parts.
8. Do not weld on wheels. Welding on wheels may cause high stress and wheel failure.
9. Do not weld on wheels with a mounted tire, Welding on wheels with a mounted tire may cause tire to burst,
causing serious injury or death.
10. Periodically tighten all bolts, nuts, and screws and check that all electrical connections are properly secured
to ensure unit is in a safe condition.
11. When completing maintenance or service function, make sure all safety shields and devices are installed
before placing unit in service.
Transport Safety
4. Do no exceed 32kph (20mph) during transport.
Safety Signs
1. Keep safety signs clean and legible at all times.
2. Replace safety signs that are missing or have become illegible.
3. Replaced parts that displayed a safety sign should also display the current sign.
4. Safety signs displayed in Safety Sign Locations each have a significant purpose and need to be cleaned or
replaced when necessary.
5. Safety signs are available from your authorized distributor or dealer parts department or from the
manufacturer.
1. Transport the Tube-line Accumulator with an SMV (Slow Moving Vehicle) sign, displayed at the rear of the
Accumulator and use your hazard lights if the law permits. Check local road laws before transporting.
2. When transporting the Accumulator on the road be aware of the width, and length of the machine.
3. Do not transport the machine, at night, at dawn, or at dusk.