Tube-Line NITRO 275RS, Operator'S Manual

Page: 25 / 49

5-1
Section 5 - Operation -
Nitro
Section 5 - Operation
Tractor Preparation
Follow this procedure when selecting and preparing a tractor for use with the machine:
1.
Use only a tractor of sufficient power and weight to adequately handle the machine. It is recommended
that the tractor have at least 125 PTO horsepower for normal operating conditions. See PTO / Horsepower
Needed, pg.2-1
.
2. Check oil level in the tractor hydraulic reservoir. Top up as required.
3. It is recommended to pin the drawbar in its centre draft position.
4. Use only a drawbar pin with provisions for a mechanical retainer. Always install the retainer.
5. Always attach a safety chain between the tractor and the machine to prevent unexpected separation.
Spreader Preparation
Your new Nitro spreader has a brief breaking-in period that you should follow for optimal operation, and for
maximum lifetime of your product. When using the machine for the first time, it is extremely important to follow
all of the procedures especially those listed below to avoid damage:
1.
Read the Nitro Operator’s Manual. Do not
operate the spreader until the safety precautions in this manual
and the decals on the spreader have been read and understood by the operator.
2. Check for proper assembly and tighten all bolts. All bolts were checked at the factory when assembled but
may need to be re-torqued as vibrations in shipment may loosen them slightly.
3.
Check tires and ensure that they are inflated to the pressure specified for the spreader’s tires.
4. Lubricate the machine. Proper maintenance and lubrication is the user’s responsibility and must begin
before the first use. Refer to
Service & Maintenance, pg.7-1
.
5.
Operate the machine slowly for a period of time to run the chains in and confirm that all parts work freely.
6.
Inspect all hydraulic lines, hoses, fittings and couplers for tightness. Tighten if there are leaks. Use a clean
cloth to wipe any accumulated dirt from the couplers before connecting to the tractor’s hydraulic system.
See
Hydraulic Safety, pg.4-3 .
7. Check the oil level in the gearboxes. Top up as required. See Grease Points, pg.7-4 .
8. Ensure that the PTO driveline is securely attached on both ends and can telescope easily. Check that the
PTO driveline shield rotates freely. Remove any debris that has become entangled in the rear beaters or
the PTO drive line.
9. Inspect all moving and rotating parts. Make sure that all guards and shields are installed and secured in
position.