Tube-Line BF5000S, Operator'S Manual

Page: 13 / 42

Stationary Balefeeder BF5000S -
Section 3: Pre-Operation 3-1
Section 3: Pre-Operation
Initial Setup
A standard BF5000S ships from the factory fully assembled. It is recommended to complete a full
inspection of all moving parts upon delivery before operating. Optional features may also be shipped
seperately and need to be installed. All needed fasteners are provided by manufacturer.
Optional Bale Bumper Installation
To install the optional bale bumper:
1. Secure two BF5000-260 bumper plates (A)
to top of frame on either side of machine
using four 5/8” x 1.75” hex bolts and 5/8”
lock nuts per side.
2.
Slide the two flange bearings
(B) onto
either side of BF5000-A20 bumper roller’s
shaft
(C) .
3.
Fasten the two flange bearings with four
7/16” x 1.5” bolts and 7/16” lock nuts to
inside face of bumper plates.
Optional Bale Extension Installation
C
B
A
A
A
C
B
B
1. Slide bale extension (A) tube ends into tube
holders (B) located on underside of bed frame.
2. Align holder holes and bale extension holes to
desired position.
3. Secure in place with four BF5000-238 pins (C)
and 1/8” x 1.5” hair pins.