3
Disclaimer
Please note: When following this construction manual properly, damage to
the SH-101 synthesizer can be ruled out.
The following installation requires some soldering. It is not compli-
cated and only basic soldering skills are needed. However please practice
on something else then your expensive synthesizer.
Tubbutec is not responsible for any damage caused by improper instal-
lation.
1
Installation of the SH-1oh1 mod
The SH-1oh1 has been designed to make installation as simple as possible.
The original SH-101 CPU needs to be desoldered and replaced with a socket.
Additionally some wires need to be soldered to points on the SH-101 circuit
boards. In order to install the midi sockets you may need to drill holes into
the plastic case of the SH-101.
1.1
Opening the SH-101
Unplug all external connection from the SH-101. Then remove all the screws
on the bottom plate. The plate now comes off.
1.2
Check Voltage
An important first step is to check the voltage of the processor to make
sure it is not higher than 5.5V. If the SH-101 is calibrated correctly this is
