7
The blower attachment is fully assembled at the factory and
requires no further assembly.
JOINING THE POWER HEAD TO THE
BLOWER ATTACHMENT
See Figure 2.
WARNING
Never attach or adjust any attachment while power head is
running. Failure to stop the engine may cause serious
personal injury.
The blower attachment connects to the power head by means
of a coupler device.
1. Loosen the knob on the coupler of the power head shaft
and remove the end cap from the attachment shaft.
2. Push in the button located on the blower attachment
shaft. Align the button with the guide recess on the
power head coupler and slide the two shafts together.
Rotate the blower attachment shaft until the button locks
into the positioning hole.
ASSEMBLY
NOTE:
If the button does not release completely in the
positioning hole, the shafts are not locked into place.
Slightly rotate from side to side until the button is locked into
place.
3. Tighten the knob securely.
WARNING
Be certain the knob is fully tightened before operating
equipment; check it periodically for tightness during use to
avoid serious injury or product damage.
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
For removing or changing the attachment:
1. Loosen the knob.
2. Push in the button and twist the shafts to remove and
separate ends.
BLOWER ATTACHMENT
POWER HEAD SHAFT
GUIDE RECESS
COUPLER
KNOB
POSITIONING
HOLE
Fig. 2
Summary of Contents for Expand-it UT15519B
Page 11: ...11 NOTES ...
