Beijing TT Aviation Technology Co., Ltd.
Add: No.1 TTA Building, Niantou Industrial Park ,Changping District,Beijing, China
www.ttaviation.org
69
7.7.1 Manually Arming and Take-off
1) Switch to
Attitude
mode.
2) Pull control sticks to the bottom inside corners to arm drone.
3) After armed, switch to
GPS
mode. Then push the throttle above the neutral position to
take off.
4) After unlocked, motor will be stopped and locked automatically if user do not push the
throttle above the 10% position from neutral in 3 seconds.
Note:
(1) Before arming, ensure no human is within 10 meters of the drone.
(2) Drone can only be armed in
Attitude
mode. After arming, pilot should switch to GPS
mode before take off drone.
(3) It is suggested to take off in GPS mode, when satellites is more than 14, no magnetic
field interference and all parts of aircraft are in good condition.
(4) Before take off, please check the
stick mode
and confirm the current settings is the
mode you want. If not, never reset by yourself without the introduction of TTA ‘s engineer.
7.7.2 Disarming
After landing the aircraft, push the throttle down and hold for 3 seconds. The motors will
be stopped, and drone will be disarmed at the same time.
Emergency disarming
: Pull control sticks to the bottom outside corners to lock
drone(
only for emergency use
. This operation can control motor stop spinning
immediately when flying).
Cautions:
1. During autonomous mode or AB mode, missions can be
interrupted
by switching the
flight mode manually. After that, operator can
fully take over
the aircraft.
2.
When drone executes protection action such as low-voltage protection and low-liquid
