© TT electronics plc
Issue A 06/2020 Page 4
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics
’
own data and is
considered accurate at time of going to print.
TT Electronics Sweden AB
Gullfossgatan 3, 164 40, Kista, Stockholm, Sweden
www.ttelectronics.com/iot
S-2CONNECT Hub
User Guide
4 Safety Precautions and Prohibited Handling
DO NOT ATTEMPT TO INSTALL, USE OR MAINTAIN THE S-2CONNECT Hub UNITL YOU HAVE READ
AND FULLY UNDERSTOOD THESE INSTRUCTIONS. BE SURE THIS INFORMATION REACHES THE OPER-
ATOR AND STAYS WITH THE PRODUCT AFTER INSTALLATION. DO NOT PERMIT UNTRAINED PER-
SONS TO INSTALL, USE OR MAINTAIN THIS PRODUCT.
Inspect the
device for physical damage and contamination. Do not connect the device, or accessory if
you detect oil, grease, water, broken or damaged parts.
When unpacking the device,
make sure to handle it with care. Rough handling may shock the device,
causing damage. Check that the device is free from cracks, fractures, leakage.
Do not place
the device near any other device that may cause sparks (such as a switch or a fuse). The
battery may generate flammable gas when charged, so always ensure the battery is kept away from
open fire and/or flames to prevent sparks from igniting or causing explosions.
Do not allow
the device to be immersed in water/sea-water.
Do not attempt to
disassemble or destroy the unit. The product must be handed over to an authorized
workshop for maintenance and to a suitable recycling station when it is taken out of service.
Use this
product only within specified temperatures.
Do not
place other products or objects on top of S-2CONNECT Hub or the performance of the device
internal antennas may be compromised.
This product contains a battery. The battery is
NOT
replaceable.
Pay special attention to the battery if the product is taken out of use, and if the product is up for dis-
posal. Dispose used batteries as hazardous waste.
