Ⅰ
.STRUCTURE
Ⅱ
.INSTALLATION
Before installation
The structure of MINI KEEPER cannot be disassembled.
If you disassemble by force, parts will be damaged or MK will not achieve a function.
(1)
Install to a shaft
①
All bores of MK are finished.
Recommended tolerance of shaft is h7 or h8.
②
Connection on a shaft use the pin pocket on the end.
As shown in the Fig. 1, a pin is inserted in a shaft and it sets to a pin pocket.
Give clearance between a pin and pin pocket as about 0.5mm.
Fig. 1
③
Refer to Table 1 for a pin and an application hole.
Model
Diameter
Strength
Application hole
MK08
2.5
14
φ
2.5
＋０．０９
０
MK10
2.5
20
MK12
2.5
24
Table 1
Pin
Size
(2)
Attachment with a driven member
Attachment with a driven member (gear, pulley or etc.) uses a jaw of flange.
Refer to Fig. 2.
―
1
―
Fig. 2
