Figure 3 Example: Open-end spanner PV-MS Figure 4 Cable diagram
6.E Bypass diode
Model type
FR607G
GSR1010HD
Voltage rating
1000 (V)
1000 (V)
Current
8 (A)
10 (A)
Configuration Single in J-box
Single in J-box
6.F Mechanical Installation
There are two mechanical installation methods, the clamp method and the bolt method. Mounting hardware
locations for both methods are illustrated in this section.
No matter which method is used, the modules are recommended to be mounted in portrait orientation (short side
parallel to ground) for best performance. If modules are mounted in landscape orientation (long side parallel to
ground), shading must be minimized as this orientation can significantly increase the impact of shading on
module performance. Please do not mount the module in landscape orientation with less than 10
°
tilt angle.
Clamp Method:
Modules mounted with clamps must have the center of the clamp positioned within the shaded clamp zones as
shown in Figure 5. This method enables a maximum mechanical loading of 2,400N/m2 (50PSF) (IEC),
