TSE DPT40-B, Owner'S Manual

Page: 162 / 472

Service As Required
RG,RG34710,5594 -19-18DEC13-1/2
RG,RG34710,5594 -19-18DEC13-2/2
Replacing Single Stage Air Cleaner
IMPORTANT: ALWAYS REPLACE air cleaner when air
filter restriction indicator shows a vacuum of
625 mm (25 in.) H
2
O, is torn, or visibly dirty.
NOTE: This procedure applies to John Deere single stage
air cleaner kits. Refer to manufacturers' instructions
for servicing air cleaners not supplied by John Deere.
1. If equipped, loosen body clamp.
2. Loosen clamp around outlet neck (A).
3. Remove air cleaner.
4. Install new filter so that overlap (B) of air cleaner outlet
neck and engine intake pipe is to specification below.
Specification
Air Cleaner Neck to
Engine Intake—Overlap................................................... 38 mm (1.5 in.)
5. Tighten neck clamp (A) to specification below.
Specification
Air Cleaner Neck
Clamp—Torque.......................................................... 6.8 N·m (60 lb.-in.)
IMPORTANT: Do NOT overtighten body clamp.
Overtightening may cause crushing of air cleaner
body. Tighten body clamp only until snug.
6. If equipped, tighten body clamp until snug.
RG1
1319A
—UN—06SEP00
Single Stage Air Filter
RG1
1320
—UN—07SEP00
Installation of Single Stage Air Cleaner
A—Outlet Neck Clamp B—Filter to Engine Overlap
IMPORTANT: Whenever the air cleaner has been
serviced or removed, ALWAYS fully depress
the air filter restriction indicator reset button
(if equipped) to assure accurate readings.
7. If equipped, fully depress air filter restriction indicator
reset button (A) and release to reset indicator.
A—Air Filter Restriction
Indicator
RG8719B
—UN—03SEP99
60-6 032715
PN=115