TSC PEX-1120 Series, User Manual

Page: 80 / 90

75

Media installation is incorrect.

Print density is incorrect.

Media feeding is incorrect.

Make sure the label guide touch the edge of the media
guide.
RTC time is incorrect when reboot
the printer

The battery has run down.

Check if there is a battery on the main board.
The left side printout position is
incorrect

Wrong label size setup.

The parameter Shift X in LCD menu is
incorrect.

Set the correct label size.

Press [Menu]

[Setting]

[Shift X] to fine tune the
parameter of Shift X.
The printing position of small label
is incorrect

Media sensor sensitivity is not set properly.

Label size is incorrect.

The parameter Shift Y in the LCD menu is
incorrect.

The vertical offset setting in the driver is
incorrect.

Calibrate the sensor sensitivity again.

Set the correct label size and gap size.

Press [Menu]

[Setting]

[Shift Y]

to fine tune the
parameter of Shift Y.
 Set the vertical offset in the driver if you’re using
BarTender.