Disable speed limiter
1)
Leave key off and locate the push button next to the dip switches on re-speed board (
Figure 5)
.
This button allows the re-speed to go into SET mode if pushed while powering up.
2)
Hold the button down and turn the vehicle on then release the button.
3)
The re-speed is now in SET mode. Get the vehicle to the maximum speed desired and push the
button again. Now the maximum speed is stored. This lets the computer only to see the
maximum speed; disabling the speed limiter. Turn the external switch to ON position. The speed
limiter is now disabled and the tachometer should never go above maximum desired speed.
Figure 5
Tire Calibration
1)
Locate the 8 pin dip switch on the re-
speed shown (
Figure 6)
. Each dip
switch combination will adjust the
speed by a percentage.
2)
To obtain the percent changes in speed
refer to the
Calibration Chart A
on the
following page
.
3)
Find your old tire diameter on the left
column. From there go over to the new
tire diameter, the cell you come to
refers to your percent change in tire
size.
4)
Next refer to the
Dip Switch Chart C
on the following page, look at the
percent change to find the dip switch
settings for the right speed
compensation.
5)
The same method is used for a change
in gears. Just refer to the
Gear Ratio
Chart B.
6)
If the vehicle has new tires and gears,
find the percent change from both
charts and add them together.
See our ReSpeed Calculator at
WWW.TSPERFORMANCE.COM
to easily obtain dip switch settings.
