TS Industrie Saelen GS/COUGAR PTO, Technical Manual

Page: 24 / 38

PRESSURE OF THE FEED DRUM ON THE MATERIAL
M A I N T E N A N C E
The feed drum exerts pressure on the material via the springs (1) .
For easier maintenance, henceforth the hammers are mounted without
lubricator but with special wear rings.
The lack of lubricators on the hammers however should not stop you from
inspecting the hammer discs and blades on a regular basis.
Upon inspection, check whether the
hammers are rotating freely.
In case there is a coarseness, spray
penetrating grease onto the axles and
tap the hammer(s) using a mallet.
Frequency of inspections
:
- control blades and hammer inserts : 50h
- Verification wear rings hammers: 200h
CONTROL BLADES AND HAMMER INSERTS