Trynex SnowEx SP-8550, Owner'S/Operator'S Manual

Page: 33 / 37

© Trynex International 2010
1 — 32
Spreader Maintenance
• WARNING – When servicing is necessary, perform it in a protected area. Do not use power tools in rain or snow because
of danger of electrical shock or injury. Keep area well lighted. Use proper tools. Keep the area of service clean to help
avoid accidents.
• WARNING – Disconnect electricity to spreader before servicing.
• CAUTION – The controller is a solid state electronic unit and is not serviceable. Any attempt to service will void warranty.
• CAUTION – There are no serviceable parts in the motor/transmission assembly. Any attempt to service will void warranty.
• CAUTION – When replacing parts use only original manufacturer’s parts. Failure to do so will void warranty.
• Use dielectric grease on all electrical connections to prevent corrosion at the beginning and end of the season and each
time plugs are disconnected.
• Gently wash unit after each use to prevent material build-up and corrosion.
• CAUTION – When pressure washing motor enclosure area, stay at least 36'' away from all electrical items.
• Paint or oil all bare metal surfaces at the end of the season.
• Apply small amount of light oil to latches as needed.
• If motor cover is removed for any reason, use silicone sealant to ensure weather proofing of enclosure.
• Grease bearings after every 20 hour’s use.
• After first use, tighten all nuts and bolts on spreader and mount.
• WARNING: Never remove spreader with material in hopper.
• ATTENTION: Store control in cool dry place during the off season.
• CAUTION – Spinner motor is not designed for continuous duty. Allow motor to cool between long cycle times.
• CAUTION – Vibrator is not designed for continuous duty. Allow motor to cool between long cycle times.
• CAUTION – Do not modify vehicle or spreader wiring harness. Doing so will void product warranty.
Model # SP-8550