21
© TrynEx International 2014 F51509 REV-A140506
Assembly Instructions
A: Loosen the Gate Stop, move the Gate Lever to the lowest position to close the Gate.
B: Move the lever to the highest position to open the gate.
C: If the Gate is not completely open when the lever is in the highest position, loosen the bottom nut on the control rod.
D: Use your hand and match up the holes on the hopper and gate so they are fully open.
E: Re-tighten the gate rod nut and check to make sure the gate operates properly when the lever is moved to the lowest and highest posi
-
tions.
F: Tighten all hardware according to the torque chart in these instructions before operating the spreader.
STEP 10: FINISHING TOUCHES – ADJUSTMENTS
Loosen the bottom nut on the Gate Rod to
adjust the Gate. The holes in the hopper need
to line up with the gate plate. When the Gate
Lever is moved fully forward, the holes should
close. The holes should be open when the
lever is completely back.
The Spinner must rotate clockwise to spread
correctly.
