17
© TrynEx International 2014 F51509 REV-A140506
Assembly Instructions
A: Attach one end of each Frame Brace to the outside of the Hopper Frame using bolt M6 x 35 and M6 lock nut.
B: Attach the other end of Frame Braces to the Wheel Frame.
C: Attach Cross Brace and secure with Hex Bolt M6x45 at both sides. Do not tighten the hardware.
A: Slip Outer Axle Bearing onto one end of the axle and secured inside the Axle Frame (there is a slot that needs matched with the frame).
Slide the Inner Axle Bushing on the axle and into placing, fitting snuggly inside the Inner Axle Bushing. Repeat this for both sides.
B: Attach Wheel to the right side of the axle by inserting a M6 x 60 bolt through both the wheel hub and axle. Fasten with lock nut M5. Refer
to the diagram below to ensure this wheel, the drive wheel, is in the correct location.
C: Attach wheel to the left side of the axle. Secure with a washer and push nut.
D: Install a Push Nut at the other end of the axle.
STEP 3: ATTACH FRAME BRACING
STEP 4: ATTACH THE WHEELS
Brace
