© Trynex International 2009 L1188
GR4 — 24
Troubleshooting
Loose electrical connections.
Blown Fuse.
Motor Seized.
Jammed auger.
Poor electrical connections.
Electrical short.
Controller failure.
Empty hopper.
Wet material.
Frozen or coarse material.
Spinner not turning.
Auger loose on shaft.
Whenever service is necessary, your local Snowex Dealer knows your Spreader best. Take your Spreader to your local dealer
for any maintenance or service needs on your unit. If this is not possible, the Troubleshooting Guide below may assist you in
Warning:
First read all warning instructions and safety messages before servicing your spreader.
Preliminary Checks
•
Be sure all electrical connections are tight and clean.
•
Be sure nothing is jammed in the hopper.
Motor doesn’t run.
Controller shut down.
Material not
flowing
from hopper.
Check all connections.
Replace fuse.
Replace motor.
Carefully clear jammed material.
Clean or replace connectors.
Use dielectric grease.
Check electrical connections.
Check for bare wires.
Replace controller.
Fill hopper.
Replace with dry material.
Replace material.
Check drive assembly.
Tighten locking bolt on the side of the auger. There is a flat
machined on the driver shaft. Align the auger with this flat
and tighten the bolt.
PROBLEM POSSIBILE CAUSE SOLUTION
locating the problem.
Model # SP-125 / US-100 / SP-225 / US-200
