Trycom Technology TRP-C68, User Manual

Page: 14 / 34

14
Then send command:”#01”……Read channel 0~7,
Response:” +02.130+07.512-01.765-02.986 +00.000+00.000+00.000+00.000,
From channel 4~7 is disable.
5-14. Read analog input channel enable/disable status
Command $ID7(CHK)(cr)
Syntax
Description
$ First leading code
ID Address of setting module from 00~FF(HEX)
7 Read analog input channel enable/disable status
CHK Checksum
(cr) Carriage return
Response !ID HL (CHK)(cr) H: Channel 4~7 L: Channel 0~3
0:Channel disable 1:Channel Enable
?ID(CHK)(cr) Command Invalid
Example:
Send command:”$017”,
Response: “!01 0F ” Channel 4~7 disable, Channel 0~3 enable.
5-15. Set up the calibration Enable/Disable
Command ~IDEV(CHK)(cr)
Syntax
Description
$ First leading code
ID Address of setting module from 00~FF(HEX)
E V V =0 Disable V =1 Enable
CHK Checksum
(cr) Carriage return
Response !ID(CHK)(cr) Command valid
?ID(CHK)(cr) Return not enable calibration before calibration command
Example:
Send command:”~01E1”,
Response: “!01”…… Enable calibration.
*Refer to paragraph 4 Function description before calibration.
5-16. Perform Zero Calibration