4
TX/RX LED
: COMA~COMD Transiting/Receiving Indicator.
2-3. Power Input
DC Jack: Power Input DC +10V to +24V. (Please use the 5.5*2.1mm DC JACK).
There are two types power input.
a. Use the plug of power adaptor than plug in the DC jack on the side.
This approach also allows the user to provide additional power to other devices using the
terminal from EU regulation.
b .Wiring terminals on the EU regulation
2-4. RST button
Keeping pushes the RST button over 10-sec when power on, and the SYS and WiFi LEDs will
blinking then TRP-C34M will be back to factory default setting.
3
.
Install TRP-C34M Hardware
STEP1:
Please connect the power source, the PWR LED will on and wait the SYS LED will
blink.
STEP2:
Connect TRP-C34M with internet port by RJ45 LAN cable.
*The TRP-C34M Support Auto-MDIX, A straight-through or crossover Ethernet
cable can be used to make a connection directly to the HUB/Router/PC.
STEP3:
Connect TRP-C34M with RS232, RS422 or RS485 with Modbus RTU or ASCII
protocol.
3-1. RS485 Wiring
3-2. RS422 Wiring
