Place the cover (C) on the side rails towards the front of the truck bed (near the cab). The front header seal is designed to help shed
water and should be sitting on top of the bulkhead.
Clamp Assembly
Height
Flush
Side Rail
Level
With Bed
Cap
To connect the cover assembly (C) to the side rails (A & B), slide the right and left header guides into the locked position. A clicking
sound will indicate a secure attachment.
Truck
Bed Cap
LEFT HEADER GUIDE
RIGHT HEADER GUIDE
5
For optimal latching performance and cover fit, the side rails
(A & B) should be level with the truck bed caps and not tilted
up or down. To fine-tune side rail tilt, you can reposition the clam
ps.
To adjust the rail tilt
upwards
, move the clamp as high as you can.
To adjust the rail tilt
lower
, slide the clamp downwards toward the
bottom of the rail. Tighten all clamps with a 1/2” wrench or socket.
7
8
Trigger Latch
6
E
TruXedo Inc.
• 2209 Kellen Gross Drive Yankton, SD 57078 • 877-878-9336 • truxedo.com ©TruXedo Inc., 2021
Part# 1118085 Rev. C 03.10.2021
Front Header Seal
Bed Rail
Side View
Bulkhead
If a bulkhead seal (E) is included with the cover, clean the top
of the bulkhead to install the seal. Peel the backing and adhere
the seal from one bedrail edge to the other. Remove any excess with
scissors or a utility knife. If the truck has a drop-in bedliner, no seal
will be needed.
