NOTE:
The trigger latch is included on the driver side rail only.
End Plug Seal
Position the driver side
rail (A) against the truck
bed rail. With the tailgate
closed, slide the rail back
until the rear seal is
slightly compressed
against the tailgate.
Adjust the rail vertically
so that the seal is flush
with the truck bed caps.
Trigger Latch
3
4
The serial number for the cover is located here.
For future reference, write it here:
___________________________________.
OWNER'S MANUAL
Damaged or missing parts?
Call 877-878-9336 Mon - Fri 8 a.m. - 5 p.m. CT
Parts will be shipped to you factory direct. Do not return kit to place of purchase.
To view install video visit truxedo.com/lopro
It is important that all areas where the bed cover mounts are
clean and free of debris prior to installing.
TOOLS REQUIRED:
•
Flat head screwdriver
•
1/2" wrench or socket
A
B
C
D
1
2
TruXedo Inc.
• 2209 Kellen Gross Drive Yankton, SD 57078 • 877-878-9336 • truxedo.com ©TruXedo Inc., 2021
Part# 1118085 Rev. C 03.
10
.2021
TOOLS RECOMMENDED:
•
Spring clamps
•
Scissors/utility knife
PARTS INCLUDED
IN YOUR KIT:
Driver side rail
Passenger side rail
Cover assembly
6x clamps
Bulkhead seal (on select make/models)
A
B
C
D
E
D
E
Attach clamps (D) starting in the middle. Evenly space 3
clamps along the driver side rail (A), leaving approximately
8" on each end. Finger tighten to make sure the teeth of the clamp
engage with the grooves of the side rail. Then tighten all clamps
with a 1/2” socket or wrench. Repeat steps 4 & 5 on the passenger
side rail (B).
D
NOTE:
The use of spring clamps to hold the side rail in place can
assist during the installation process.
